USB 3.0 Cable Modules

Part Number: 
QTL1309

Perform automated cable hot-swap and fault injection on USB 3.0 Cables

USB 3.0 Cable Module - Front
USB 3.0 Cable Module - Rear

Product Information

The USB 3.0 Cable Pull Module is an automated solution for hot-swap testing and fault injection on USB 2 and 3 cables. Automation provides easier, faster and more detailed testing. Consistent, repeatable results reduce time to market and improve reliability.

The modules can be easily integrated into existing your test setup, or can be used separately as a manual or fully automated bench test.

This module requires purchase of a separate controller

Features

  • Automated hot swap of USB2/USB3 cables
  • Create hard faults in data and VBUS connections
  • Simulate intermittent faults
  • Improve test coverage while decreasing duration
  • Ideal for bench testing, debugging, and evaluation

Technical Specification

  • 1ms timing resolution on all switches
  • 10us pin-bounce resolution on all switches
  • 50ns PRBS or user sequenced glitch pulses on all lines
  • Supports Low Speed, Full Speed, High Speed and Super Speed
  • Requires Torridon Array Controller or Interface Kit
  • l=84.0mm w=63.5mm h=30.0mm
  • Up to 4 units can be rack mounted in 1U, with separate kit

Product Variants

QTL1309

USB 3.0 Cable Module

QTL1971

USB Type-C Cable Module

Required products

Related products

Similar products